Build A Welded Wire Fence

Posted on May 4, 2018 By


The Items You Need

Garden arbor can make a difference to the entire landscape.– 4×4 Posts
– 2×4 Lumber
– 1×4 Lumbe
– Deck Screws
– Concrete Gravel
— Welded Wire Fence Rolls
— Gate Hinges and Latches
— L-Brackets
– String Stakes
— Level
– Tape Measure
– Post Hole Digger
– Power Drill
– Circular Saw

Measure out where you want any additional posts between the corners. Roughly 7-8 feet between posts is typical, but don’t spread them a lot more than 10 feet apart. Mark all these spots with stakes along the thread line. Be sure that you indicate out a section for the gate.

Fill the bottom of the hole with pea gravel for drainage so your posts don’t rot from the ground up. Saw your 4×4 posts if necessary. With an assistant, set your article in the ground. Check both the side to side and vertical level, then add tangible to the hole while your helper holds the post steady. Periodically check the concrete level as you include it and after the hole is totally filled. Let each post sit down for several days or until the cement has set. Check it regularly in the first 24 hours to be certain it doesn’t move while drying out.

Measure out a section between 2 posts for the gate. Subtract a good inch to get the width of your door (this inch allows room for this to swing open and closed). Cut two 2x4s to this size. Measure how tall you want the particular gate, and cut two even more 2x4s to fit between your top plus bottom boards. Bolt them along with L brackets on both sides of every corner (8 brackets total). Measure from one top corner diagonally right down to the bottom corner. Cut a panel to length (with 45 diploma cuts on the end to fit in the corners) and screw it to your door. Drill your latch and handles to your gate. Prop it up having a scrap of 1×4 or 2×4 and mark on your posts where you can drill your latch and door on. Be sure to account for similar excess space on both sides regarding swinging, and attach the {gate|

Backyard FenceDIY Fence TipsFront Yard Fence     , ,


    Leave a Reply

    Your email address will not be published. Required fields are marked *